| 1 |
Start engine.
And wait until the engine warmed up about 5 - 6 munites.. |
| 2 |
Stop the engine. |
| 3 |
Remove (=displace) air cleaner. |
| 4 |
Remove (=displace) the fuel hose from the engine, then start engine
again.
Run engine until all remaining fuel fully consumed.
|
| 5 |
Inject whole contents of TEC from intake manifold while running starter-motor.
| Warning-1 : Don't use for diesel-engines assembled
on Corrola, Sprinter and Calina made by Toyota (Toyota 1C engine, shown
a photo).
|
| Warning-2
: In case using for diesel engine, it is necessary to inject TEC while
running engine to protect "water-hammer problem" caused by smaller displacements. |
|
| 6 |
Wait about 5 - 10 munites until fully activated. While waiting,
reset the removed hose to the original position. |
| 7 |
Start an engine and idle until smokes disappear. |
| 8 |
After idling settles down, adjust idle screws for normal idle
RPM if necessary. |
.jpg)
__ 
