.jpg)
|
| 1 |
Warm up an engine and comfirm it. |
| 2 |
Remove an intake manifold side of rubber hose between air valve and
intake manifold shown as circled in the illustration above. When
removing it, an engine stops, and so plug it with fingers so that an engine
may not stop by sucking air, push in a nozzle, hold it, spray whole contents
in it and stop the engine. Be careful for the nozzle not to be sucked
and pulled inside. Reset the rubber hose and leave a car for 3 to
5 minutes (longer the time, better the effect). Start an engine again
and idle until white smokes disapppears. Do not idle at too high
speed (No racing).
Refer following photos
| 1 |
Front of M-EU engine
|
| 2 |
Pointing air valve
|
| 3 |
Pointing a rubber hose connection closer to intake manifold and further
to air cleaner from air valve. Spray TEC from this point. |
| 4 |
Just removed the rubber hose.
|
| 5 |
Engine running, hold a hole and nozzle of TEC so that air may not be sucked
in and spray whole contents of TEC. Be careful for nozzle not to
be sucked and pulled in. |
| 6 |
Stop the engine. After 3 to 5 minutes, reset the removed hose to
the original position, start an engine and idle until smokes disappear.
After idling settles down, adjust idle screws for normal idle RPM. |
|
|
__ 
